Follow

How do I configure my Pulse Internet Wireless Network?

How to configure your Wireless Network?

To configure your Pulse Internet Wireless Network, you need to access the configuration interface. This can be done by following these steps:

  1. If you cannot access the wireless LAN, you must first establish a wired Ethernet connection between your computer and the router.

  2. In your web browser, open the page http://192.168.0.1/ to access the wireless router setup.

  3. When the Login screen displays. Enter the user name and password and click the Apply button to log in.

    Note: The default user name is “admin”. The Media Gateway default password is “password”.

  4. The System Basic Setup screen displays. Set basic setup configuration parameters as required for your system.

    Note: Most configuration parameters that you may want to set can be accessed on the System Basic Setup or under the More LAN Settings and More Wireless Settings links.

 

Once you've logged in to the configuration interface you can change your password by following these steps

  1. Access and log into the configuration interface.
  2. Click the Basic Setup tab.
  3. Click Change Password in the side menu to display the change password screen.
  4. Enter your old password.
  5. Enter your new password twice.
  6. Click the Apply button.

 Note: Passwords are case-sensitive. Valid characters are the numbers 0 to 9, the letters a through z and A through Z, and printable special characters (such as $, !, ?, &, #, @, and others.)

 

 

To enable or disable the Wireless Network following these steps

  1. Access and log into the configuration interface.
  2. Click the Basic Setup tab.
  3. Click the Enable Wireless checkbox to enable wireless networking.
  4. Click the Apply button at the bottom of the screen.

 

Was this article helpful?
0 out of 0 found this helpful
Powered by Zendesk